SURFACE PRODUCTION OPERATION AND EQUIPMENT

SURFACE PRODUCTION OPERATION AND EQUIPMENT

Hotel Holiday Inn, Bandung | 25 – 27 Juni 2013 | IDR 9.750.000,-
Hotel Holiday Inn, Bandung | 3 – 5 September 2013 | IDR 9.750.000,-




SASARAN BELAJAR :

Setelah menyelesaikan kursus ini diharapkan peserta dapat :

  • Memahami prinsip-prinsip dasar penggunaan peralatan sumur produksi di atas permukaan, untuk lapangan-lapangan minyak dan gas bumi .
  • Melakukan diagnosis sederhana dalam menagani problema produksi di lapangan yang disebabkan oleh reservoir atau fasilitas produksinya.
  • Melakukan perhitungan-perhitungan kuantitatip sederhana untuk perancangan dan perancangan ulang separator, gas scrubber, gas dehydrator dan peralatan produksi lainnya.
  • Memahami prinsip-prinsip dasar perhitungan dan melakukan optimisasi pada saat operasi produksi sumur-sumur minyak, gas dan reservoir panas bumi dilaksanakan, pengembangan pelaksannaan optimisasi produksi ini untuk meningkatkan kinerja produksi sumuran dan lapangan.
  • Melakukan diagnosis sederhana dan memengerti penyelesaian permasalahan dalam operasi produksi sumur-sumur minyak dan bas bumil.



PRE-REQUISITE :

Latar belakang : Operator/ Sr. Operator/ Jr. Engineer/Non Engineer


MATERI KURSUS :

  1. • Gathering system manifold and flow line design & sizing
    •  Oil Gathering System
    •  Maniflod System
    •  Flowline Sizing and Design
  2. • Oil and gas separation: separators, dehydration
    •  Separator and Principle of Separation
    •  Design of Separator
    •  Oil Dehydration
  3. • Well surface operation and equipment, operation, automatic safety devices
    •  Oil Well Equipment
    •  Oil Well Production Operation
    •  Well Automatic Safety Device
  4. • Oil and gas measurement : measuring instrumentation and system
    •  Introduction to Measurement
    •  Crude Oil Measurement
    •  Gas Measurement
  5. • Well test-general : responsibility, preparation, oil well test, gas well test.
    •  Introduction
    •  Responsibility for Test
    •  Preparation for Test
    •  Types of Well Test
    •  Equipment and Procedures
    •  Accuracy of Fluid Measurement
    •  Problem in Testing
    •  Type of Test
  6. • Gas Piping System
    •  Basic Flow Equation
    •  Flow in Wells and Flow in Pipelines
    •  Effect of Liquids
    •  Use of Pressure Traverse Curve
    •  Liquid Removal from Gas Wells
  7. • Gas Compression
    •  Type of Compressors
    •  Compressor Design
    •  Centrifugal Compressor
  8. • Total System Analysis
    •  Tubing and Flow Line Effect
    •  Separator Pressure Effect
    •  Compressor Selection
  9. • Flow Measuring
    •  Orifice Metering
    •  Metering System Design
    •  Other Metering Methods
  10. • Gas Condensate Reservoir
    •  Well Testing and Sampling
    •  Gas Cycling
  11. • Field Operation Problems
    •  Pressure Cumulative Production Plot
    •  Hydrate Formation
    •  Sour Gas Production
    •  Corrosion Control With Inhibitors
    •  Sulfur Deposition
  12. • Gas Processing
    •  Field treatment of Natural Gas
    •  Gas Plant Operation
    •  Gas Dehydration
    •  Gas Sweetening



INSTRUKTUR :

Dr.Ir. Sudjati Rachmat, DEA

DR. IR. SUDJATI RACHMAT, DEA was graduated from Petroleum Engineering Department of ITB in 1979 and hold Doctorate Degree with honored in 1987 from Ecole Centrale de Lyon I, France. The topic of his thesis is Modelisation Numerique d’Ecoulements Polyphasiques en Milieux Poreux Application au Cas de Calcul des Champs de Pressions et de Saturations dans un Gisement de Petrole.
For the time being, he became a lecturer in Petroleum Engineering Department of ITB. His subjects are Analysis and Numerical Method, Engineering Mathematics, Computer Simulation, Fluid Mechanic, Artificial Intelligence for Petroleum Engineering.
He also gave many courses to the community, such as: basic reservoir engineering and reservoir simulation, basic production engineering, down hole well testing, statistic and numerical method for petroleum engineering, basic log interpretation, etc. He is a member of some profession organization such as: IATMI, SPE/EIME, IMA, HAIAI, FPS-USA,

ASISTEN : Ir. Iwan Mulyawan



VANUE AND DATE

Vanue : Hotel Holiday Inn Bandung
Date :

  • 25-27 Juni 2013 ( Batch I )
  • 3-5 September 2013 ( Batch II)



FACILITIES

  • Training Kit
  • Soft Copy Material Training On Flashdisk 4GB.
  • Coffee Break & Lunch
  • Certifikat
  • Souvenir
  • Additional Program (optional)



INVESTATION

  • IDR 9.750.000,- /Participant Non residential.
  • For send 3 participant from the same company IDR. 8.250.000,-/participant.

Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages.
  • TwitThis
  • Facebook
  • LinkedIn
  • Google Bookmarks
  • Y!GG
  • Digg
  • del.icio.us
  • StumbleUpon
  • Reddit
  • MySpace
  • Technorati
  • YahooMyWeb
  • YahooBuzz

About the Author:

Post a Comment